UNIMEC Pneumatic-Swing Clamp Cylinder TA SERIES

● These swing clamps are used when it is required to keep the fixture workpiece area free of straps and clamping components for unrestricted workpiece loading and un-loading. ● This pneumatic clamping

TA Pneumatic-Swing Clamp Cylinders

● These swing clamps are used when it is required to keep the fixture workpiece area free of straps and
clamping components for unrestricted workpiece loading and un-loading.

● This pneumatic clamping element is a pull type cylinder, There are five standard sizes, and for each size
two versions of standard clamping arms,mounting of these clamping arms at any angle within 360°

● Please don’t exceed 1.5 times of the original length, if it is necessary to increase the length of the
clamping arm.

● Suggested to install a flow control valve protect cylinder barrel and internal components against fretting
wear.

 

Specification

Type TAS TAS..M TASL TADL TAD TAD..M
Bore sizes of cylinder (mm) Ø25 Ø32 Ø40 Ø50 Ø63 Ø32 Ø40 Ø50 Ø63
Operation Double acting
Power fluid Filtered air with or without lubrication
Max. pressure (MPa) 1.03
The range of pressure (MPa) 0.1 ~ 0.7
Material of cylinder barrel Anodised aluminium alloy
Standard angle of rotation 90° ±2° (Angle of 0° ,45° and 60° are optional)
Rotating direction Clockwise or counter clockwise

How to order

TA How to order
No reprinting without permission:Ruhong Seiko (Xiamen) Electronics Technology Co.,Ltd. » UNIMEC Pneumatic-Swing Clamp Cylinder TA SERIES
Share To:
Pneumatic
Components
Hydrulic
Components元件
Transmission
Equipment
Instruments
Apparatuses