These are Solenoid Operated Directional Valves of high pressure, high flow and low pressure drop, the features of which can be materialized by employing a powerful wet type solenoid and the rational flow channel design.
● High Pressure & High Flow Rate
In comparison to our existing lines, both the pressure and flow of
these valves are much increased.
● Max. Operating Pressure: approx. 10 % increased [31.5→35 MPa(4570 →5080 PSI)]
● Max. T-Line Back Pressure: approx. 30 % increased [16→21 MPa(2320 →3050 PSI)]
● Max. Flow Rate: approx. 60 % increased [63→100 L/min (16.64→26.42 U.S.GPM)]
● Low Pressure Drop
The pressure drop of these valves is reduced by 10 % from 1.0 to 0.9
MPa (145 to 131 PSI), in comparison to our existing lines*; the valves
effectively reduce the energy consumption of the unit.
{* At Flow Rate: 60 L/min (15.9 U.S.GPM), Spool Type: 3C2 (P→A)}
● Compact & Small Mass
Despite of high pressure, high flow and low pressure drop, these valve
bodies are compact and lightweight with DC double solenoids; the
overall length and mass are reduced from 210 to 205 mm (8.26 to 8.07
inch) and from 2.2 to 1.85 kg (4.85 to 4.08 lbs), respectively.
● Shockless type available
In addition to the standard valves for high pressure and high flow, a
shockless type capable of minimizing noise and vibration in piping
during spool changeover is also available.
● Stable Operation
Due to the powerful magnetic and spring force of the solenoids, these
valves exhibit a high tolerance to contaminants and especially stable
operation.
● IP65-equivalent high dust- and water-proof
These valves demonstrate excellent dust- and water-proof
characteristics, in compliance with I. E. C. Pub. 529. IP65 and JIS C
0920 IP65 (dust- and jet-proof type).
● Usable in products of various standards
These standard valves are CE certified for installation in equipment overseas.
UL/CSA certified products are also available.

Specifications:★ 1.For details of L-DSG-01, please contact us.
★ 2. Maximum flow indicates a ceiling flow depends on the type of spool and operating condition, refer to the List of Spool Functions on pages for details.

Sub-plate

Sub-plates are available. Specify the sub-plate model number from the table above.
When sub-plates are not used, the mounting surface should have a good machined finish.

Mounting bolt

For socket head cap screws in the table below are included.

Solenoid Ratings：★ 1.AC solenoid is not available in shockless type.
R type models with built-in current rectifier is recommended for shockless operation with AC power.
★ 2.Inrush current in the above table show rms values at maximum stroke.
★ 3.There are more coil types other than the above. For details, please make inquiries.